Small Scale Gold Milling Equipment

Small Scale Gold Milling Equipment

Guide: There are several kinds of wear-resistant parts of the Small Scale Gold Milling Equipment. It is a series of machines with a large number of wear-resistant parts in direct contact with the materials in all the mills produced by the company. Its main wear-resistant parts are grinding rolls. Grinding rings, grinding discs, shaft pins, etc.

Brief introduction of Small Scale Gold Milling Equipment wear parts

The main wear parts of the Small Scale Gold Milling Equipment include grinding rolls, grinding rings, grinding discs, shaft pins, and two bulk discs. The grinding disc is a component located in the middle of these wear-resistant s. It has an upper bulk disc mounted on it, and a lower bulk disc mounted on the bottom. The middle of the grinding disc is connected with dozens of grinding rollers through the shaft pin. There is a grinding ring on the outside of the part.

The functions of the grinding roller and the grinding ring are all used to crush the material, so that the material layer is ground to form a finished product. The role of the pin is to fix the grinding roller, but the roller is not fixed, it can leave outward with the centrifugal force. The function of the bulk disc is to disperse the material to the surrounding area, which facilitates the entry of large pieces of material into the grinding part. The function of the lower bulk disc is to disperse the material to the surroundings, so that the powder material is subjected to the pumping action of the wind and enters the dust collector along with the wind.

The main wear parts of the Small Scale Gold Milling Equipment, the functions of these wear parts are as described above, but the walking path of the materials in these wear parts is as follows. The material enters the inside of the machine from the inlet, and then falls on the upper bulk disc. Because the upper bulk disc rotates with the grinding disc, the material will enter the grinding roller at the edge of the bulk disc under the action of centrifugal force. In the gap of the grinding ring, the material enters from the gap of the first layer and is then ground. Then the material continues to move down under the action of gravity, and is ground in the first and third layers, and falls into the lower part of the machine. The bulk disc disperses the powder material around it for easy removal by the wind. The material is taken to the classifier by the wind. If the powder is fine enough, it can leave the machine through the classifier and enter the next device. However, if the fineness of the powder does not meet the standard, it cannot pass through the classifier, and can only enter the grinding part again under the action of gravity. Grind until the standard is reached, you can pass the classifier.

The wear parts of the Small Scale Gold Milling Equipment need to be replaced frequently because they are in contact with the material. It must be replaced regularly, but the user needs to decide whether to replace it according to the wear condition of the machine.