Silver Mining Process Equipment

Silver Mining Process Equipment

 Silver Mining Process Equipment feeding precautions

Silver Mining Process Equipment feeding precautions

The material in the Silver Mining Process Equipment will form a layer of material during grinding. The thickness of the layer affects whether it works smoothly. Two phenomena occur in the milling production. One is that the material layer is too thin, and the other is that the material layer is too thick, which will cause the machine to work unsmoothly. Let's take a look at the treatment of the material layer.

If the material layer in the Silver Mining Process Equipment is too thick or too thin, the grinding roller of the machine will not be crushed to the material, which is the pressure, which will cause the machine to vibrate abnormally, thus affecting the normal operation of the grinding work. The following is explained from two aspects of the thickness of the material layer.

There are two reasons for the thin layer in the Silver Mining Process Equipment, one is that the feeding amount is small, and the other is the problem of materials. When the feed amount is too small, the material is discharged from the machine while being continuously milled, and the speed at which the material is discharged from the machine is constant, which causes the inner layer of the machine to become thinner and thinner, which may cause the roll and The grinding disc is in direct contact with the vibration, and the direct contact between the grinding roller and the grinding disc can also cause wear of the grinding roller sleeve and the grinding disc, accelerate the aging of the two, and increase the cost of the user in the cost of the wearing part.

The reason of the material itself will also cause the material layer to become thinner. When the material hardness is low and brittle, even if the material layer of the Silver Mining Process Equipment is thick, the air pressure of the grinding roller may occur due to sudden crushing of the material, causing damage to the machine. Great damage. In view of the problem that the feeding layer is small, the user can increase the feeding amount. For the problem of the material itself, the user needs to appropriately reduce the pressure of the grinding roller, increase the water spray amount, and appropriately increase the feeding amount.

The excessive feeding amount in the Silver Mining Process Equipment causes the phenomenon of “plowing material” on the grinding disc, and the material layer is unstable, so that intermittent contact between the grinding roller sleeve and the grinding disc causes damage. The plow material is that the material is brought up under the rolling of the grinding roller, so that it is piled up to other locations, causing some areas to be thin, while in some places there is material accumulation. In the face of this phenomenon, the user needs to reduce the amount of feed, and it is better to grasp the basic information such as the amount and size of the feed during the trial operation of the machine, so as to save time and waste caused by errors in the system work.